(CC_a028) Unable to charge – Incorrect switch setting Adjust rotary switch setting in Wall Connector

Find it. Solve it.
Post Reply
thaterrormessage
Site Admin
Posts: 7238
Joined: Tue Jul 14, 2020 3:21 pm

(CC_a028) Unable to charge – Incorrect switch setting Adjust rotary switch setting in Wall Connector

Post by thaterrormessage »

What this alert means:
Incorrect rotary switch setting.

What to do:
Make sure there is no power to the Wall Connector. Remove the face plate and adjust the rotary switch to a valid operating current setting. The correlation between switch setting and current is printed on the inside of the Wall Connector. You can also refer to the Set the Operating Current section in the Wall Connector Installation Manual. If the Wall Connector is set up for load sharing (paired with other Wall Connectors), the rotary switch of the master unit must be set to an operating current setting that allows each paired Wall Connector to receive at least 6A of charge current. Example: Three Wall Connectors are paired for load sharing. The master unit needs to be set to a current of at least 3 * 6A = 18A or greater.
*IS THIS ERROR HAPPENING NOW? Reply in real-time below.* Hold software providers accountable - we rely on the community to acknowledge the same errors and their workarounds/fixes. Register to search and full board access.
Post Reply